Switch, Clutch Control, Remove and Install
Remove, Disconnect Detach footwell panelling and remove from bracket (1). Remove heating and ventilation ducts. |
|
Press clutch pedal forwards (1). |
Remove actuating pin from switch (2). |
Remove locking sleeve (3). |
|
|
Remove, Disconnect Press in lugs, remove switch, release and disconnect wiring harness plug. |
|
Important! Actuating pin (1) of switch must be pulled out to stop before installation, as otherwise self-adjustment is not possible. In this case, contact remains constantly closed, and provides the electronic cruise control with incorrect signals. Pull out locking sleeve (2) completely, as otherwise switch cannot be installed. |
|
Install, Connect Engage switch in pedal support, holding clutch pedal down. Check that actuating pin (2) of switch is pulled out to stop. Press locking sleeve into switch (1). |
|
When the pedal (1) returns to the output position, the actuating pin (2) automatically assumes the correct position. Connect wiring harness plug, install heating and ventilation duct and footwell panelling. |
|
|