DTC C0561
Diagnostic Instructions
DTC Descriptors
DTC C0561 71: System Disabled Information
Stored-Invalid Serial Data Received |
Circuit/System Description
The parking brake control module has an internal motor, apply
actuator, release actuator, and temperature sensor. The parking
brake control module also contains the logic for applying and
releasing the parking brake when commanded by the park brake
control switch. When the parking brake control module receives a
signal from the switch the internal circuit board temperature is
checked to verify it is within operating range before the control
module performs the requested operation. The parking brake module
will verify it has a valid signal from other modules before it
performs the requested operation.
Conditions for Running the DTC
• |
Ignition OFF, ACCESSORY, or
RUN mode. |
• |
Battery voltage is between
9-16V. |
Conditions for Setting the DTC
The parking brake control module receives an invalid serial data
message or does not receive a serial data message from another
module.
Action Taken When the DTC Sets
• |
A message and/or a warning
indicator may be displayed. |
• |
The electric parking brake
functionality is degraded. |
Conditions for Clearing the DTC
• |
The parking brake control
module clears the history DTC when a current DTC is not detected in
40 ignition cycles. |
• |
The parking brake control
module receives Valid signals from other modules. |
Reference Information
Schematic Reference
Park Brake System Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Electronic Parking Brake Control Module Description
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
1. |
Using the scan tool, locate
the Invalid parameter in the Data Display. |
2. |
Refer to the appropriate
module to diagnose the invalid data signal. Do not replace the
electric parking brake control module. |
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic
procedure.
|