Fog Lamp Aiming
Preparation Procedure
Note: Horizontal aim is not
adjustable on this vehicle. Vertical aim is done by a dial located
under the fog lamp. Prior to aiming the fog lamps, perform the
following steps:
| 1. |
Completely assemble all of the
components on the vehicle |
| 2. |
Place the vehicle on a level
surface. |
| 3. |
Stop all unnecessary
operations or work that could affect the ride height of the
vehicle. |
| 4. |
Close the doors and verify
that the luggage compartment is empty. |
| 5. |
Stabilize the suspension by
rocking the vehicle sideways. |
| 6. |
Ensure that the fuel level is
full. |
| 7. |
Ensure that the tires are
inflated to the proper pressure. |
| 8. |
Ensure that the driver or a
similar weight , approximately 75 kg (165 lb), is in the
vehicle driver seat. |
Aiming Procedure
| 1. |
Park the vehicle 7.6 m (25 ft)
away from the target screen. |
| 2. |
Measure from the center of the
fog lamp to the ground line. Using this measurement, mark the
horizontal centerline (2) of the fog lamp on the target screen
directly in front of the vehicle. |
| 3. |
Turn ON the fog lamps. The top
of the fog lamp beam image (1) on the target screen should be
102 mm (4 in) below the center of the fog lamp lens
height. |
| 4. |
Adjust the fog lamp as
required using the dial under the fog lamp behind the front of the
front bumper fascia. |
| 5. |
Turn OFF the fog lamps.
|
|
