Instrument Panel Wiring Harness Replacement
Removal Procedure
Note: Arrange a place to
embed the removed parts.
1. |
Install the MDI, turn on the
ignition and read the diagnostic trouble codes. |
|
• |
Delete all diagnostic trouble
codes and read diagnostic trouble codes again. |
|
• |
Notice ALL diagnostic trouble
codes. |
5. |
Release all mass cables from
the tie bar and body weld studs. |
6. |
Release the instrument panel
wiring harness. |
|
Make pictures from the routing and fixing points of the
instrument panel wiring harness for the orientation. |
7. |
Disconnect all electrical
connectors and unscrew the ground cables. |
|
7.1 |
Release all fixations.
|
|
7.2 |
Take care about destroyed
cable straps and harness guidance regarding noises and
rattles. |
8. |
Remove instrument panel wiring
harness (2) from instrument panel tie bar (1) and lay it on the
floor. |
|
Unpack the new instrument panel wiring harness and compare the
old with the new harness concerning quantity of fixing points,
cable straps, guides, part numbers and pin assignments. |
Installation Procedure
1. |
After comparing the new with
the old harness (2) install the harness on the tie bar (1).
|
|
• |
Check if there is no twisting
and bending and fix the new wiring harness. |
|
• |
Use new cable straps and pins.
Connect all electrical connectors. |
|
• |
Take care for the correct
counterpart and the pin assignment. |
|
• |
Use the pictures for
orientation. |
2. |
Tighten all mass cables to the
weld studs to 9 N·m (80 lb in) .
|
8. |
Install the MDI, turn on the
ignition and read the diagnostic trouble codes. |
|
Delete all diagnostic trouble codes and read trouble codes
again. |
9. |
Check all electrical functions
and perform a test run. |
|